Inhoudsopgave
Advertenties
H. Vollmer GmbH
4. Before Installation/Commissioning
The power distributor may only be operated once removed from the packaging.
Remove the product from the packaging carefully.
Make sure that the connection levels for your building's installation corresponds with the data on the
product type plate.
Make sure that the power distributor has not been damaged during transport before taking it into
operation. The light may not be operated if there are any damages to electrical parts. Repairs may only
be carried out by a qualified electrician.
Keep packaging materials away from children and pets. Danger of suffocation!
5. Installation/Commissioning
This product may only be installed by a qualified electrician.
The connection lines in the building must be disconnected before installation and secured against being
switched back on. For this, trip the corresponding fuse switch in the building installation.
Choose where to attach the product. Make sure that no water can accumulate around the power
distributor's position.
Make sure that the surface is suitable for permanently and reliably taking the weight of the power
distributor. It may only be taken into operation in an upright position!
Now connect the building installation's connection lines to the screw terminals on the light. Connect the
green-yellow protective conductor first and then the other two cables. The brown (or black) cable is
generally the phase conductor - connect this to the terminal marked with "L". The blue conductor must
be connected to the terminal marked with "N".
Pay attention to possible tripping hazards, especially in walking areas, when laying the cable.
Do not bend the cables; make sure that the cables and plugs are not subject to tension or torsional
forces. Protect all cables and insulation against possible damages.
Check proper connection once again.
Make sure that the maximum capacity of the power distributor is not exceeded before connecting a
consumer.
Switch the building installation's fuse switch back on.
6. Faulty Function
Connected consumers won't switch on
Consumer defective?
Voltage test
Check the connected lines
Fuse switched on?
Installation Instructions Art. No. 37505
Page 2 of 3
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
Dated 24.08.2015
Advertenties
Inhoudsopgave
