Advertenties
•
Insert the power plug into an earthed outlet.
Note: Please observe that the power plug must still be able to be reached after
installation of the electric fireplace insert.
Avoid the power line from becoming a trip hazard. Therefore, always run it away from
the unit from the back.
Your electric fireplace insert is now ready for operation.
Operation
Note: When the heater is turned on for the first time, a slight, harmless odour can develop.
This odour develops due to the heating up of the inner heating elements. Provide sufficient
ventilation.
Switching flame simulator on / off
Note: You can also switch on the flame simulator when you are not using the heating
function.
Note: Power consumption of the electric fireplace insert with illumination switched on but
without heating function amounts to approx. 2 W.
•
Open the cover 3 by opening it up towards the front.
•
Set the ON / OFF switch 6 to position I.
•
Set the ON / OFF switch 6 to position 0 if you would like to turn off the flame simulator.
•
Close the cover 3.
Using the dimmer function
Note: Your electric fireplace insert has a dimmer function. With it you can adjust the
brightness of the flame simulator.
Note: You can only use the dimmer function when the flame simulator is switched on (see
'Switching flame simulator on / off').
•
Open the cover 3 by opening it up towards the front.
•
Set the ON / OFF switch 6 to position I.
•
Turn the dimmer 9 clockwise to increase, or anti clockwise to reduce, the brightness of the
flame simulator.
•
Set the ON / OFF switch 6 to position 0 if you would like to turn off the flame simulator.
•
Close the cover 3.
Switching heating function on / off
Note: The electric fireplace insert has one heating stage.
8
Advertenties
