Inhoudsopgave
Advertenties
ERRORS
Symptom
Possible cause
Error code ER03.
The control panel is dirty or
has water on it.
Error code E3.
Unsuitable pan used.
Error code E2.
Appliance over heated.
Fault code E6.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
The fuse in the appliance will
Appliance is connected to
blow if all 4 cooking zones are
a 1 phase/16 Amp and not
used on a high power level.
adjusted to "Lo" by software.
Zone(s) don't work or don't
Appliance is connected to
heat up sufficiently.
a 1 phase/16 Amp and not
adjusted to "Lo".
Other fault codes.
Defective generator.
Solution
Clean the control panel.
Use a pan suitable for
induction cooking.
The appliance has been
switched off because of over
heating.
Have your connection
changed.
Set the appliance to "Lo"
(power limiter). Refer to the
installation instructions.
The appliance's inbuilt power
limiter limits the maximum
power that can be used
simultaneously. Refer to the
installation instructions.
Contact the service
department.
EN 15
Advertenties
Hoofdstukken
Inhoudsopgave
