Inhoudsopgave
Advertenties
GB
INSTRUCTION ON MOUNTING AND USE
Check also the drawings on the initial pages with the alphabetical
and numerical references in the explanatory text.
Closely follow the instructions in this manual. We cannot
accept liability for any faults, detriment or fire damage to the
appliance due to non-compliance with the manual's
instructions. Installation and electrical connections must be
executed by a qualified technician. You should affix the hood
to a wall of sufficient weight-bearing capacity, so not to one
made of plasterboard. Do not install it inside a cupboard.
Installation
The cooker hood must be placed at a minimum distance of 65
cm from the cooking plane for electric cookers and 75cm for
gas or mixed cookers.
If the instructions for installation for the gas hob specify a greater
distance, this has to be taken into account.
Do not tile, grout or silicone this appliance to the wall. Surface
mounting only. Do not fix chimney flue to furniture or fly over
shelves unless the chimney flue can be easily removed, in
case maintenance is ever required.
Electrical connection
Make sure that there is a power socket near the hood and
that the system has a 30 mA differential. The mains voltage
must be the same as that on the label inside the hood. The
hood has a 1250 mm power cable with or without plug: if it
does have a plug, connect the hood to an accessible
approved socket; or if it does not (connection direct to the
mains), fit an approved bipolar switch with a minimum
contact opening of no less than 3 mm (accessible). This
installation and electrical connection must be executed by a
qualified technician.
Operation
General Notes: the control system is touch-sensitive. To
activate any function, it is only necessary to touch the
button lightly.
Light ON/OFF: switches the hood lights on and off.
Motor ON/OFF (8 speeds+2 timed high speeds): tapping
this control will start and stop the motors.
Speed control buttons: Pressing the „1,2,3,4,5,6,7,8"
buttons sets the speed (power) of aspiration desired. The
speed can be selected directly, or by gradually changing
through the possible speeds.
High Speed 1: tapping this control activates the „High Speed
1" aspiration speed. This will time-out after approx. 8 minutes,
after which the speed will return to level 8.
High Speed 2:
tapping this control activates „High Speed 2"
aspiration speed. This will time-out after approx. 7 minutes,
after which the speed automatically reverts to level 8.
Grease filters saturated: when the motor is started, this
indicator button will light for five seconds in a colour that
shows the level of filter saturation: Green 0-75%, Orange 76-
99%.
If the indicator shows a constant red, this means the metal
grilles need to be washed (typically after 40 hours of use).
Carbon filters saturated: when the motor is started, this
indicator button will light for five seconds in a colour that
shows the level of filter saturation: Green 0-75%, Orange 76-
99%.
If the indicator shows a constant red, this means the carbon
filters need to be washed or replaced (typically after 120
hours of use).
RESET FILTERS
„Grease / Carbon filters saturated" when the indicator
button shows red, pressing it will reset the indicator.
WARNING: This operation should be performed only
after correct maintenance of the respective filter(s).
NOTE: after four hours of uninterrupted operation since
the last touch of any of the cooker hood's buttons, the
hood will switch itself off automatically.
Advertenties
Inhoudsopgave
