Operating - Ferm CDM1118 Vertaling Van De Oorspronkelijke Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor CDM1118:
- Vertaling van de oorspronkelijke gebruiksaanwijzing (125 pagina's)
Inhoudsopgave
Advertenties
Description
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A
1. Machine
2. Battery
3. Battery unlock button
5. Charger
6. Charger LED indicator
7. Chuck
8. Gear selection switch
9. Direction switch
10. On / off switch
11. Torque adjustment ring
12. Work light
3. OPERATING
The battery must be charged before first
use.
Removing the battery from the machine
Fig. B1 + B2
• P ush the battery unlock buttons (3) and pull
the battery out of the machine like shown in
Fig. B1.
Inserting the battery into the machine
Fig. B1 + B2
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• I nsert the battery (2) into the base of the
machine as shown in Fig. B2.
• P ush the battery further forward until it clicks
into place.
Charging the battery (with the charger)
Fig. C
• P lug the charger plug into an electrical outlet and
wait for a while. The LED indicator on the charger
(6) will lighten up and show the charger status.
6
All manuals and user guides at all-guides.com
LED indicator (6)
Fig. C
The charger has 1 LED indicator (6) which
indicates the status of the charging process:
LED
Red
Green
• F ully charging the 1.5Ah battery may take up
• A fter the battery is fully charged remove the
Fitting and removing drills or screwdriver bits
Fig. D
The drill chuck (7) is suitable for drills and screw d river
bits with round shaft as well as hexagonal shaft.
• H old the machine firmly with one hand
• O pen the drill chuck (7) by rotating the chuck
• I nsert the shaft of the drill or screwdriver bit
• T ighten the drill chuck again by firmly rotating
• C heck if the bit is centered well by shortly
Adjusting the gears
Fig. D
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (8) forward or
backwards. The number on the gear switch (8)
shows which position is chosen.
• P osition 1: For slow drilling, large drilling
• P osition 2: For fast drilling or small drilling
Charger status
Battery charging in progress
Battery charging finished, battery fully charged
to 60 minutes.
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used over
a longer period of time it is best to store
the battery in charged condition.
Always remove the battery before
mounting an accessory.
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
the chuck (7) counterclockwise.
activating the machine´s on/off switch.
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between both
positions, this will damage your machine.
diameter or screw driving. The machine has
high power at a low speed.
diameter
Advertenties
Inhoudsopgave
