Inhoudsopgave
Advertenties
Section 2 - Installation
1
Mark where you want to install the sensor. Ensure that the probe
/
cable can reach the location where you want to detect the presence
of water.
Note: You can extend the cable length by using a 3.5 mm stereo audio
extension cable.
2
Use a 6 mm drill bit to drill two 25 mm deep holes over the marks.
/
3
Twist the screws into the wall, leaving the tops of the screws
/
exposed from the surface. Do not over tighten the screws.
D-Link DCH-S161 User Manual
Mounting the Device
2.6 ~ 3.0 mm
10
Advertenties
Inhoudsopgave
