Inhoudsopgave
Advertenties
Assembly
defective parts, guarantee claims against the
manufacturer are excluded.
■
Repair work is only allowed to be carried out
by expert workshops or our service centres.
3.6
Safety instructions relating to operation
■
Never leave the operational appliance unsu-
pervised.
■
Clean the appliance after every use.
■
Protect the appliance against unauthorised
access.
■
The appliance may only be operated by one
person.
■
Never move the appliance while the motor is
running.
■
Disconnect the appliance from the mains for:
■
Maintenance and cleaning work
■
Adjustment work
■
Transport
■
Interruptions in work
■
Faults
■
During the splitting process, do not reach into
the splitting area and do not touch the split-
ting wedge.
4 ASSEMBLY
WARNING! Danger if assembly is not
carried out completely! Operation of an incom-
pletely assembled appliance can result in serious
injury.
■
Only operate the appliance when it is fully as-
sembled.
■
Check that all safety and protective devices
are in place and functioning correctly before
switching on.
4.1
Assembly for LSH 370/4 (06 – 15)
Assemble the appliance in the order of the fig-
ures (06) to (15).
4.2
Assembly for LSH 520/5 (17 – 27)
Assemble the appliance in the order of the fig-
ures (17) to (27).
4.3
Installing protective cover (29 – 31)
Assemble the protective cover in the order of the
figures (29) to (31).
462706_n
5 START-UP
5.1
Setting up and connecting log splitter
WARNING! Danger of injury if the log
splitter tips over. A tipping log splitter can result
in serious injury and material damage.
■
Set up the log splitter on firm and level
ground.
■
Do not place any material under the log split-
ter to change its height or to try to increase
its stability.
1. Set up the log splitter horizontally and se-
curely so that it cannot tip over.
2. Anchor the log splitter to the ground at the
appliance leg using two suitable screws
(16/1, 28/1) and possibly dowels to prevent it
from tipping over.
3. Lay the mains cable in such a way that it can-
not be kinked, crushed or damaged in any
other way.
4. Open vent screw (01/4, 02/4) by roughly 1 –
2 turns so that the air can escape that is dis-
placed during operation by the heated and
expanding oil.
5. Insert the plug of the mains cable into the
power socket.
Note: To disconnect the appliance from the
mains power supply, pull out the plug again.
5.2
Inspect safety and protective devices
Always check before starting work:
1. Check the proper anchoring of the log splitter
to the ground and correct, if necessary.
2. Inspect the protective cover for damage. Re-
pair the protective cover, if damaged.
3. Inspect two-hand operation: Procedure, see
see chapter 6.1 "Splitting a log (32 – 34)",
page 30. While the log pusher is moving, re-
lease either ON button or control lever. The
log pusher moves back to its starting posi-
tion.
29
Advertenties
Hoofdstukken
Inhoudsopgave
