Inhoudsopgave
Advertenties
User manual
Translation of the original
instructions
ASSEMBLY OF THE SEAL
Fit the seal, starting at the mark on the plate.
Pinch the gasket into place in the groove.
Be careful not to stretch the seal.
Check that the seal is correctly inserted in the
groove.
Make the joint by slightly compressing the joint.
The joint must not be cut. If there is too much len-
gth, the joint is overstretched. Put it back in place
without stretching it.
12
User manual
AIRFIX DRAW ALIGNER
Translation of the original
instructions
ASSEMBLY
Screw the silencer onto the Venturi block by hand
Safety washer M10: 8
Screw the left and right brackets to the base of the co-
lumn using an H8 spanner.
Be careful to position the column with the
notches on the right side, see image.
Safety washer M10: 6
Screw the column / brackets assembly to the plate using
an H8 spanner.
Safety washer M10: 2
Screw the wheel supports to the plate using an H8
spanner.
Safety washer M10: 4
Screw the wheels and their axles to the wheel brackets
using an H8 spanner.
AIRFIX DRAW ALIGNER
Screw M10x25: 8
Screw M10x18: 6
Screw M10x18 : 2
Flat washer M10 : 2
Screw M10x18: 4
13
Advertenties
Inhoudsopgave
