Inhoudsopgave
Advertenties
WARNING: Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Do not use a brush or compressed air to clean
the dust collector or filter.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the dust extractor.
These chemicals may weaken the materials used in these
parts. Use a cloth dampened only with water and mild
soap. Never let any liquid get inside the dust extractor;
never immerse any part of the dust extractor into a liquid.
During intensive use the dust collector becomes clogged
with dust. Refer to Replacing The Dust Collector Box Filter
Assembly, under Maintenance.
For cleaning and maintenance in a way that avoids exposing
maintenance personnel and other persons to any hazards, wear
personal protective equipment. Clean the maintenance area in a
way that prevents hazardous substances from escaping into the
surrounding environment.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product,
E
use of such accessories with this dust extractor could
be hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
The replacement filter (N703592) is available as an accessory at
additional cost.
Wireless Tool Control™ remote (optional accessory N547456)
Consult your dealer for further information on the
appropriate accessories.
WALT Bluetooth® Tool Tag Ready (Fig. K)
D
E
Optional Accessory
WARNING: Read instruction manual for the D
Bluetooth® Tool Tag.
WARNING: Turn dust extractor off and disconnect battery
pack before installing the D
WARNING: When installing or replacing the D
Bluetooth® Tool Tag, use only the screws provided. Be sure
to securely tighten the screws.
Your dust extractor comes with mounting holes
a D
WALT Bluetooth® Tool Tag (DCE041). Use only the original
E
fasteners included with the tool tag. You will need a T15 (Torx)
bit tip to install the tag. The D
tracking and locating professional power tools, equipment, and
machines using the D
WALT Tool Connect™ app. For proper
E
installation of the D
WALT Tool Tag refer to the D
E
Tag manual.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
WALT
E
WALT
E
WALT Bluetooth® Tool Tag.
E
WALT
E
for installing
19
WALT Tool Tag is designed for
E
WALT Tool
E
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to
produce sufficient power on jobs which were easily done before.
At the end of its technical life, discard it with due care for our
environment:
•
Run the battery pack down completely, then remove it from
the dust extractor.
•
Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
EnGLIsh
37
Advertenties
Inhoudsopgave
