Inhoudsopgave
Advertenties
17 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
17.1 Security advices
ATTENTION
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
17.2 Troubleshooting
Problem
"Add Water"
indicator is on.
"Ice full" indicator
is on
Ice cubes stick
together.
Ice making cycle
is normal but no
ice formed.
► If above mentioned steps don't solve the problem, please contact your customer
service.
18 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or
Possible cause
Lack of water.
Ice is full in basket.
The ice making cycle is
too long.
Water temperature in
inner tank is too low.
Room temperature or
water temperature in
inner tank is too high.
Not enough cooling
liquid in the coolant
reservoir or a part of the
electronics is defect.
Please note
Solution
Stop the ice maker and press "Power"
button again to restart the unit.
Remove ice from ice basket. Continuously
press "Select" button 5 seconds. The ice
maker could make ice 10 cycles, before "ice
full" indicator is on.
Stop the ice maker and start it again when
the ice blocks are melt. Select the small size
ice cube selection.
Replace the water. Temperature of water
recommended at 8-32°C.
The room temperature should be 5-40°,
water temperature should be 8-32°C.
Contact your customer service.
34
Advertenties
Inhoudsopgave
