Advertenties
6. Technical data
Installation dimensions
L x W x H
Suction connector,
connection diameter
Hose length mm
Air flow rate
Pressure difference Pa
Filter surface
Filter volume
Weight
Drive
Electric motor
Input power P1
Engine speed
Subject to technical changes!
7.
Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove packaging material and all transport safety
devices (if applicable).
• Make sure that the delivery is complete.
• Check the device and accessories for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the end of the
warranty period.
• Familiarise yourself with the product by means of the
operating instructions before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
435 x 345 x 230 mm
35 mm
2000 mm
120 m³/h
20000 Pa
0,175 m²
5 l
5,5 kg
220-240 V~ / 50/60 Hz
1250 W
28000 min
-1
www.scheppach.com
8. Assembly
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
Ensure that the machine is standing on level and firm
ground.
Inserting/replacing the dust bag (fig. 2/3)
• Open both clamps (3) and fold the case cover back-
wards. Open the lid for the dust bag (10), press the
clamping bracket (12) on the dust bag and push it
over the suction nozzle.
• Close the lid again until it clicks into place. When
you empty a full dust bag, clean the dust bag cham-
ber with a moist cloth or brush before you inserting
it again.
• Pass the connection cable through the notch (a) on
the front. Close the case cover and lock it with both
clamps.
Suction function (fig. 4 - 7)
• Remove the power plug for all conversions.
• When using the suction function, always insert a
dust bag. The connection nozzle (14) must be in-
serted on the side of the dust bag. (16) Insert the
suction grating with filter on the opposite side. Make
sure both parts click into place. Insert the suction
hose (6) with the lug into the connection nozzle (14)
and lock in it place by rotating it slightly.
• Attach a jet nozzle onto the suction hose; connect
the mains plug and press the on button.
Function: Blowing out, off and up (fig. 4 - 7)
• The conversion of the device for blowing out can be
done in a few simple steps.
• Remove the connection nozzle (14) from the suction
side and insert on the opposite side. (17)
• Insert suction grating with filter on the suction side.
Connect the suction hose and attach the blowing
nozzle (7).
• Keeping the hole on the jet nozzle closed will in-
crease the blowing pressure.
• Do not point the air flow at persons or animals.
Working instructions
Prior to every start-up of the machine, inspect the
equipment for proper function.
GB | 19
Advertenties
