Inhoudsopgave
Advertenties
6. Clean the feeder unit and working unit before running the machine.
Troubles and Solutions
Fault
Not crashing or crashing
inefficiency.
Temperature of bearing is
too high.
Machine vibration or noise.
Maintenance
Ensure the bearing has sufficient and clean lubrication.
Regularly check and replace damaged parts such as square teeth, T-teeth, or sieves.
Tighten or replace the triangle belt as needed.
Damageable Parts
Square gear
T-type gear
Powder sieve
Triangle belt
Bearing
Possible Causes
1. Low speed.
2. Damaged sieve.
3. Worn teeth or hammer.
4. Wet material.
5. Damaged driving shaft.
1. Insufficient lubricant.
2. Worn bearing.
3. Excessive feed.
1. Loose parts.
2. Rotor imbalance.
3. Damaged driving shaft.
EN
1. Maintain rated speed.
2. Replace sieve.
3. Replace teeth/hammer.
4. Dry material.
5. Maintain or replace the driving shaft.
1. Replace grease.
2. Replace bearing.
3. Control feed volume.
1. Fasten parts.
2. Balance rotor.
3. Maintain or replace shaft.
Solutions
Advertenties
Inhoudsopgave
