Inhoudsopgave
Advertenties
Mulch
„Mulching" is a process in which the grass is finely chopped by a
special cutting system and then deposited on the ground. The re-
sult is that the grass does not have to be collected and disposed
of. „Mulching" also prevents the lawn from drying out.
3
Instructions for mulching
We recommend:
z Depending on the growth of grass, mulch 1 – 2 x per
week
z The grass should not be too high nor too wet!
z Go slow while mulching
z Take care that the blade channels do overlap.
z Do not cut grass more than 20 mm.
Maintenance
General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z pull out the power plug.
z Do not touch running blades.
Cleaning
z Clean mower thoroughly after each mowing with cloth or
brush.
z Clean the mulch flap at regular intervals with a small
broom
V
.
z Do not spray with water.
Winter Storage
z Clean mower thoroughly before storing away.
z Have your mower thoroughly checked once a year by an ap-
proved Service Centre.
z Do not store it in a wet or humid place.
Spare parts
Item number
4904 031
4907 031
4913 095
4904 096
4907 096
14
All manuals and user guides at all-guides.com
Order description
Vi 32 FM
Vi 34 FM
Vi 37 FM
3
Note:
Mulching is not advisable in case of moss-affected or
entangled grass, because the cut material stays on the
moss surface and/or entanglement and thus cannot be
absorbed by the ground.
z Regularly scarify and manure the lawn.
Activating the mulch function
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
z Do not start the motor until your feet are at a safe distan-
ce from the cutting tool.
1. Remove the grass collecting bag.
2. Set the switch to „MULCH".
3. Start the motor.
Changing blades
W
z For all works on blades, coupling and cutter bars, first of all,
pull out the power plug and wear protective gloves.
1
Attention!
An unbalance can develop after regrinding of the blade.
z Always regrind the blades in a specialist workshop,
because an unbalance check should be undertaken
according to the safety regulations.
z Always change blades in a specialist workshop. A torque
spanner of 10 mm is mandatorily required.
Fastening torque of the screws: 6 - 7 N-m
Product information
Grass catcher (32/34)
Grass catcher (37)
Replacement blade 32 cm
Replacement blade 34 cm
Replacement blade 37 cm
S
W
.
G
Advertenties
Hoofdstukken
Inhoudsopgave
