Operation
Disconnecting the battery clamps (fig. 7, page 7)
1. Disconnect the black (bk) battery clamp.
2. Disconnect the red (rd) battery clamp.
9.7 Charging via USB
I
NOTE
• Charging of digital mobile devices is not possible while the jump starter is being
charged.
• Two digital mobile devices can be charged at the same time by using both USB out-
puts.
➤ To charge digital mobile devices, use the USB adapter cable provided and proceed as shown (fig. 8, page 8).
✔ The LCD display shows the remaining state of charge of the jump starter.
9.8 Operating 12 V devices
I
NOTE
Operation of 12 V devices is not possible while the jump starter is being charged.
➤ To operate 12 V devices, connect the power cable of the 12 V device to the 12 V DC output of the jump starter
(fig. 2 4, page 4).
✔ The LCD display shows the remaining state of charge of the jump starter.
9.9 Wireless charging
I
NOTE
Ensure the device supports wireless charging.
➤ To wireless charge devices, press the
page 8.
➤ The LCD display shows the remaining state of charge of the jump starter.
18
button and place the device on the wireless charging pad, see fig. 9,
PJS1000
EN