Inhoudsopgave
Advertenties
ENGLISH
Automatic channel search
Press MENU à Channel à Auto Tuning and confirm with OK button. Select the country
(default ITALY) and press OK to launch the scanning.
At any time, pressing EXIT or Menu, the scanning can be stopped.
WARNING! Automatic channel searching deletes all channel lists previously saved.
DVB-C mode (via cable) is available to receive the digital channels, select DVB-C and press
OK to launch the scanning.
WARNING! Make sure to not select this mode in case of traditional terrestrial antenna
system.
WARNING! The reception and therefore the viewing of digital terrestrial channels depends
on the level and the quality of the antenna signal available The signal varies according to
the area in which you live, to the correct orientation/functioning of the antenna system and
to the quality of the signal transmitted by the digital terrestrial repeaters
Channel list editing.
Press MENU à Channel à Edit Program and confirm pressing OK. Once displayed the list,
the options are:
RED (Delete): select one or more channels, delete them pressing RED button.
Blue (Skip): select the channel and press BLUE button, once activated the channel can be
selected with the numeric keys of remote control unit.
Yellow (Move): to move a channel, select the channel you want to move, press the Yellow
button, use arrow keys to move the channel to the desired position or enter the desired
position number, then press OK to confirm.
Satellite mode
If you choose satellite, you can choose to load a default satellite channels list by pressing
OK and confirming Yes (left arrow) to the confirmation request; or proceed with normal
installations, once the satellite parameters are set, scan type, channel type and type of
service, by pressing OK and choosing No (right arrow) on the next screen.
To activate the digital channel reception mode, press the Source à Satellite. You can scan
the frequencies available with your satellite antenna system, automatically searching for
all the satellite channels from the first installation or through an automatic scanning
available in the Channels menu.
Impostazione Antenna
the basic settings to allow the use of the TV with a single Universal LNB (Low Noise Block
converter) system (commonly used for satellite systems in Italy); in the event your system
is done with a different configuration, you must appropriately change the antenna settings.
WARNING! The wrong antenna configuration can result in the failure to load some or all
channels. If you do not know the characteristics of your antenna system and/or are unable
to properly configure the receiver yourself, you may want to consult a professional installer
for advice. The power and signal quality indicators refer to the first transponder of the
chosen satellite list
Restore Factory Settings
This function allows you to restore factory settings. To do so, select Restore settings ... and
on the new screen, select YES. The television will be restored to its factory settings.
Advertenties
Inhoudsopgave
