Inhoudsopgave
Advertenties
4.
Press the
button to turn on the control panel. Press the
button to infl ate the spa tub wall for 8 to 10 minutes until it is fi rm
to the touch but not hard (see drawings 4 & 5).
IMPORTANT: Do not over infl ate or use high pressure air
compressor to infl ate.
5.
Press the
button again to turn it off .
6.
Replace the air valve cap back.
The cap is designed to be screwed on and off . Never exert force
as this could cause the complete internal infl ation system of the
valve to come loose. See "Spa Tub Air Valve Fastening" for valve
maintenance.
NOTE: If there is a need to replace the spa tub air pressure release
valve core (23) due to wear and tear, use the included wrench (22) to
unscrew the core from the valve base. Insert the replacement core and
tighten with the wrench. Make sure the core is securely tightened (see
drawing 6).
Infl ate the Spa Cover Air Bladder
1.
Open the infl ation valve and insert the infl ation hose (7) into the
valve; press
to infl ate until it is fi rm to the touch but not hard
(see drawing 7).
2.
Disconnect the infl ation hose (7) from the air blower infl ation outlet
and the valve.
3.
Replace the control base infl ation latch back; close and recess the
infl ation valve.
NOTE: If there is a need to add some air to the spa tub wall or spa
cover air bladder after they have been setup, refer to above "Infl ate the
Spa Tub Wall" and "Infl ate the Spa Cover Air Bladder" sections. The cover air bladder is preinstalled inside
the spa cover. If it needs to be reinstalled, place the uninfl ated air bladder inside the spa cover lip before
infl ating the bladder.
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 04/16/2022
SET UP (continued)
IMPORTANT: To prevent damage to the air blower motor never
block the air blower outlet opening during infl ation.
English
4
23
22
7
Page 12
347
A
5
6
7
Advertenties
Inhoudsopgave
