Inhoudsopgave
Advertenties
•
Humidity is a natural side eff ect of indoor spa installation. The room shall be properly ventilated to allow
moisture to escape. Install a ventilating system to prevent excess condensation, moisture in the room.
•
Have consideration when removing the spa from the chamber/building without destroying part of the built
structure. Where non-porous duckboard type fl ooring is used, make sure it is equipped with a drainage
system underneath to allow cleaning and easier removal. When spa is located indoors, watch out for
areas that have high water tables as they are prone to fl ooding.
Additional requirements for outdoor installation
•
Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting, and other safety requirements. Contact your local building code enforcement offi ce for further
details.
•
Make sure the surface is level, fl at, smooth and strong enough to support the full weight of the fi lled spa.
•
Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and
damage the spa fl oor.
•
Do not expose the spa to direct sunlight for extended period of time. Provide protection from the
sun such as sunshade, tent, awning or gazebo.
•
It is possible to install and leave the spa outside at a temperature not lower than 4°C (39°F) provided the
water temperature inside the spa is higher than 4°C (39°F) and the water inside the circulation system,
pump, pipe are not frozen. Put a "temp barrier mat" between the spa fl oor and the ground to prevent heat
loss from the bottom of the spa and to provide better heat retention. Do not use the spa if the ambient or
water temperature is 4°C (39°F) or lower.
•
Pay attention to local environmental conditions, such as ground water and risk of frost when install the
spa. Professional installer shall have a discussion of these conditions with the client.
Setup the spa with at least 2 persons.
1.
Move the entire package to the selected site. Do not drag the spa tub across the ground as this can
cause damage and leakage.
Open the carton carefully as this carton can be used to store the spa during long term storage or when
not in use.
2.
Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or
damaged parts contact the appropriate Intex Service Center listed in the separate "Authorized service
Centers" sheet.
Spa Control Panel Adjustment
1.
Push the lever down to tilt up the control panel and fl ip up the panel cover (see drawing 1.1).
2.
To stow the control panel back push the button located on the back inward while pushing the control
panel down (see drawing 1.2).
S AVE THESE INSTRUCTIONS
(347IO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 04/16/2022
SET UP (continued)
1
2
347
English
A
1.1
1.2
Page 10
Advertenties
Inhoudsopgave
