- before any cleaning
- after each use.
• Never use an extension cable that has been damaged.
• Never carry or pull the device by the power cable.
• Penetrating the housing with any kind of object is strictly prohibited.
• If the supply cord is damaged, it must be replaced by the manufacturer, an authorised representative
or a qualified person in order to avoid a hazard.
• Do not pull the power cable over sharp edges or allow it to become jammed.
• Never remove the plug from the socket by pulling at the power cable and never remove it with wet
hands.
• Do not use this humidifier in close proximity to a bath tub, shower or swimming pool (always ensure
a minimum distance of 3m). Always place the device in a position where it cannot be reached by
anyone in the bath tub.
• Do not set up the device near a source of heat. Do not subject the power cable to direct heat (such
as heat from hot oven hobs, naked flames, hot irons or heating furnaces). Keep the power cable away
from oil.
• Do not position the device directly next to walls, curtains or furniture.
• Ensure that the device is stable during operation and that no-one can trip over the power cable.
• The device is not splash-proof.
• Do not store or use the device outdoors.
• Store the device in a dry place, out of the reach of children (in its box).
• Never touch the ultrasonic membrane (inside the device) when the device is in operation. The mem-
brane' s oscillations can cause injuries similar to burns.
• Do not add anything to the water (fragrances, essential oils or water fresheners).
Do not place the device directly on the floor. Use a water-proof underlay!!
FIRST USE / OPERATION
Please note: never transport the device with a full water tank.
Possible hazards:
- there is too much water in the base of the housing and the spraying power is severely reduced.
- water can escape
- the water tank can fall and become damaged (and water can leak on to the floor).
1.
For this reason, base (5) of the Stylies Aquila humidifier should initially be placed in a suit-
able location separately. Important: Soak the anticalc cartridge in a water bath for 24
hours beforethe first use (not in the water tank!). The resin has to absorb water to reach-
high performance.
2.
When this base is in the desired location: Fill water tank (4) with water (hold the filling
opening slightly upright) – screw the lid back on firmly and check that it is water-tight.
Place water tank on base. Attach power supply (1) to mains socket on the reverse side (2)
and the household plug socket.
3.
Press the on/off switch (6) to start up the unit. The control display and the water tank now
light up in blue. Once the water is used up, the display changes to red and the humidifier
switches off. The steam outlet (2) can be rotated by 360°.
4.
Press the on/off switch (6) again to switch off the light in the water tank; the unit remains
in operation, however. Pressing the on/off switch (6) once more switches off the humidi-
fier completely.
9