Inhoudsopgave
Advertenties
4.-
EN
light
(Maximum/Medium/Minimum)
If the RH of the room is below the desired RH, select the maximum flow.
5.-
between 1-12 hours. After this time, the unit will stop automatically.
The display will intermittently indicating the remaining time.
6.-
When the water tank is empty, the same symbol flashes and the appliance emits an
audible warning signal.
Note : It is recommended to clean the appliance following the recommendations in the
section MAINTENANCE, before filling the water tank again.
5. REMOTE CONTROL
-
Using the remote control, you can control and program the humidifier.
-
Before using the remote control for the first time, remove the plastic film that protects
the battery.
-
Always point the remote control at the receiver located at the front of the screen.
-
The remote control can work at a distance from the receiver up to about 3 metres,
always check there are no obstacles that distort communication.
-
Ensure that the battery of the remote control is correctly located. When replacing the
battery, make sure it is the same type.
-
The remote control should not be exposed to shock, moisture and prolonged
exposure to sunlight.
-
Do not misuse the remote control.
6. MAINTENANCE
-
Before any cleaning or maintenance on the appliance, disconnect the appliance from
the mains.
-
Clean all areas that come into contact with water regularly (twice a week) with a damp
cloth, including the transducer and the steam generation pipe. Do not use detergents as
they could damage the transducer.
-
How to clean the transducer : Place 5-10 drops of vinegar on the transducer and wait
10 minutes. Using a small brush, remove lime scale carefully. Then finish with clean
water.
12
M A X- M IN
By MAX-MIN control, you can select three humidity flow rates. The two
columns
of
the
With TIMER control, you can program the device operating time
T IM ER
When the water tank is empty, this symbol appears in the display.
display
indicate
the
selected
flow
rate
Advertenties
Inhoudsopgave
