Download Inhoudsopgave Inhoud Print deze pagina

Commissioning; Functions And Programming (Fig. 4) - S&P HUMI-E D Handleiding

Inhoudsopgave

Advertenties

3. COMMISSIONING

1.- Always place the appliance on a stable, completely horizontal base, at least 20
cm away from the wall. Make sure that is not accessible to children, etc..
2.- Remove the top cover and remove the water tank (Fig.2).
3.- Unscrew the plug placed at the bottom of the water tank (Fig.3) and fill the water
tank with clean water and without fragances and a temperatura of less than 40ºC. To
avoid lime scale problems it is recommended to use distilled water.
4.- Screw the plug, tightening securely.
5.- Place the water tank into its initial position. Ensure that if is securely seated in the
main humidifier body.
6.- Replace the top cover and position the moisture diffuser, so that the moisture flow
is not projected on the wall, furniture, TV, power supply, power cable, wooden
flooring, remote control...etc.
7.-
Connect the plug to the mains. (Check that the data on the name plate coincides
with the mains voltage).

4. FUNCTIONS AND PROGRAMMING (Fig. 4)

Before commissioning the humidifier, you should know that the comfortable humidity level
in a room at 18-20ºC is between 50-60% RH.
1. Once the humidifier is connected to the electrical supply, the display of the control
panel will light, indicating the temperature and relative humidity in the room.
Note: If the appliance has been moved from another room, wait for the sensor to
stabilize for about 10 minutes, to take actual readings of temperature and humidity in
the room.
2.- Press the POWER button to start the unit.
H U M ID IT Y
3.-
With the HUMIDITY selector, program the % of Relative humidity required
in the room. The setting range is between 45-90% RH with variations of 5%.
If the RH in the room is lower than the desired RH, the unit starts running. Otherwise, if
the RH in the room is already above the desired RH, the unit is in standby mode. At the
time that the RH drops below the programmed HR, the unit will automatically operate.
Continuous operation mode (CO). If this mode is selected, the device will generate
humidity permanently, regardless of humidity level in the room.
EN
11

Advertenties

Inhoudsopgave
loading

Gerelateerde Producten voor S&P HUMI-E D

Inhoudsopgave