Inhoudsopgave
Advertenties
1.
Slide open the lid on the receiver.
2.
a. Push and hold buttons A and B on the hand control
simultaneously for five seconds until the LED C starts
flashing to indicate that the hand control is in pairing
mode.
The pairing mode will be active for seven
second and automatically stop if a pairing is
not established within this time frame.
b. While the hand control is in pairing mode, push
and hold button D on the receiver until the LED
E is flashing twice to indicate that the pairing was
successful.
3.
Close the lid on the receiver.
5 Using the Wireless Hand Control
A
B
C
D
The hand control is equipped with buttons for electrical
functions (A to G), up and down buttons (p and q) to
control the selected function
When a button is pressed and the hand control is
communicating with the receiver the LED H will flash in blue.
When a locked function is selected the LED H will flash in
yellow.
1660535-B
H
E
F
G
ErgoMove™
1. Press button A to select the function.
2. Press and hold button p to raise to
a pre-defined sitting position, by a
pre-defined sequence of movements.
3. Press and hold button q to lower to a
horizontal position.
Height adjustment
1. Press button E to select the function.
2. Press and hold button p to raise the bed.
3. Press and hold button q to lower the bed.
Up-and-Out™ position
1. Press and hold button B to move to a
pre-defined position to get out of the bed
easily.
Back section
1. Press button C to select the function.
2. Press and hold button p to raise the back
section.
3. Press and hold button q to lower the back
section.
Leg section
1. Press button F to select the function.
2. Press and hold button p to raise the leg
section.
3. Press and hold button q to lower the leg
section.
Thigh section
1. Press button G to select the function.
2. Press and hold button p to raise the thigh
section.
3. Press and hold button q to lower the thigh
section.
Anti-Trendelenburg function
1. Press button D to select the function.
2. Press and hold button p to tilt to a head
end up position.
3. Press and hold button q to tilt back to a
horizontal position.
6 Exchanging batteries
The wireless hand control is powered by 2 AAA 1.5 V
batteries.
To exchange the batteries:
3
Advertenties
Inhoudsopgave
