Inhoudsopgave
Advertenties
The humidity
is not reduc-
ing
Dehumidifier
is blowing
out warm air
Water on
floor
Water in tank
overflows
The dehumid-
ifier
is noisy
Error code
"Lock" display The control panel is locked
"LO" display
"HI" display
MV-2565-04-2024 eeese-aircare.com © All rights eeese air care aps
The dehumidifier has not been
used long enough.
The ambient temperature is too
low
The surrounding humidity level is
too low
The ambient humidity level is
lower than the desired humidity
level set
The air filter frame is dirty
The dried air is passed over heat-
ing coils before it is blown into
the room as part of the dehumidi-
fying process
There is residual water in tank,
and the device is lurched too
much by moving
The water tank may be damaged
Float for water auto-sensor is not
in place
Internal drainage passage is
blocked or obstructed
The pre-filter is blocked or the
device is on an uneven surface
E1: Temperature sensor error
E2: Humidity sensor error
Ambient humidity is lower than
30%.
Ambient humidity is higher than
90%,
Be patient and wait
Reduce the ambient
temperature
This is normal. You can doublech-
eck with a hydrometer
This is normal. You can
doublecheck with a hydrometer
Clean the pre -filter frame
This is normal, a dehumidifier is not
an air cooler
Be careful when moving the tank
Contact our eeese service line
Clean the pre-filter or put the
device on a flat surface
Contact our eeese
service line
Press and hold the Timer
button for 2 seconds
to unlock the panel
Raise the humidity level
Lower the humidity level
UK
79
Advertenties
Hoofdstukken
Inhoudsopgave
