Inhoudsopgave
Advertenties
Operation
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
•
Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
•
Do not place uncovered items as below inside
the appliance, as this can lead to a damaged
and leaking evaporator, and thus void your
warranty: hot food, hot liquids, acidic fluids,
acidic products.
•
Wrap or cover food where possible.
•
Do not obstruct the fans inside the appliance.
•
Avoid opening the doors for prolonged periods
of time.
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
3. Turn the light switch On [I] or Off [O] as
desired.
Control Panel
To unlock / Lock the keyboard press
together for 3 seconds. Display will flash PON
(unlocked) / POF (locked).
Set the Operating Temperature
1. Press the SET button for 2 seconds. The value
of the set point will be displayed and the °C
LED starts blinking.
2. Press the
or
required temperature.
3. Press the SET button to store the temperature.
UA040-UA041-UA042-UA043_ML_A5_v2_20241108.indb 5
UA040-UA041-UA042-UA043_ML_A5_v2_20241108.indb 5
and
buttons to display the
Manual Defrost
Press and hold the defrost button
to begin a manual defrost. The defrost light
illuminates.
The defrost cycle will end automatically.
Cleaning, Care &
Maintenance
Defrost appliance at least every 3
•
months, more often if required.
Switch off and disconnect from the power
•
supply before cleaning.
•
Clean the interior of the appliance as often as
possible.
•
Do not use abrasive cleaning agents. These
can leave harmful residues.
•
Clean the door seal with warm soapy water.
•
Always wipe dry after cleaning.
•
Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
•
Take care when cleaning the rear of the
appliance. Sharp edges can cut.
Refrigerating tips:
•
Condensation and ice will form with frequent
and prolonged opening of the doors.
•
Operating outside of the recommend
temperature range and placing next to a heat
source will also increase the amount of ice
and internal/external condensation. If external
condensation occurs wipe the surface down
with a cloth.
•
Excessive ice will result in longer running times
that will increase energy consumption and
increase the deterioration of components.
•
If the gasket or seal is damaged or deformed,
energy consumption will increase. To restore
efficiency, replace gasket.
•
Do not obstruct fans and do not exceed
max load lines, as doing so will impact air
distribution and increase energy usage.
EN
for 3 seconds
5
2024/11/8 13:53
2024/11/8 13:53
Advertenties
Inhoudsopgave
