English
‧ Protect the mains socket and
mains plug against moisture
and wetness. A drip loop
must be formed with the
mains cable. This prevents
any water running along the
cable to the mains socket,
which would result in a
short-circuit.
‧ The electrical data of the
appliance must match the
data of the power mains. This data is found on the type
plate, the packaging and in these instructions.
‧ The distance from the underside of the light to the high-
est water mark must be a minimum of 15 mm.
Commissioning
Installation (⌦A)
1. The LED lights can be adjusted to the width
Electrical connection
1. Connect the plug of the LED lights to the
The matching EHEIM power supply unit can be
found on the packaging of your LED light.
Operation
Service life
In order to avoid excessive algae formation,
you should not put the LED lights in continuous
operation.
Optional accessories
Use with Y distributor
The Y distributor allows you to operate two LED lights from
one power supply unit.
Ensure that the maximum power output of the
power supply unit is not exceeded (see Techni-
cal Data, page 98)
Use with T5/T8 adapter
With the T5/T8 adapter, you can replace traditional fluores-
cent bulbs with an LED light. To do so, proceed as follows:
1. Push both adapter parts together
onto the extendable bracket
DANGER! Electric shock!
▶ Before all assembly work, remove the mains
▶ Keep the lighting unit or cover disconnected
▶ Secure the mains plug of the lighting unit or
2. Loosen the end cap
bulb.
3. Insert the LED light with the T5/T8 adapter
lamp socket
4. Screw down the end cap.
of your aquarium with the freely adjustable
extendable bracket
ble bracket out of the light housing until it
reaches the desired length.
socket of the matching EHEIM power supply
unit.
plug of the lighting unit and or cover.
from the mains!
cover against any unintentional connection
to the socket
⑤
via the end cap.
⑥
. Pull the extenda-
①
②
(⌦C).
①
and remove the fluorescent
13
Drip Loop
/
until they click
③
into the
⑦