Inhoudsopgave
Advertenties
Switch (Fig. A)
The spotlight has a high beam and low beam setting. Press the
1
switch
once for high beam, twice for low beam, and a third
time to turn the spotlight off.
Low Battery Indicator
As the battery nears a fully discharged state, the spotlight
will blink twice and then dim, dropping the brightness of the
spotlight below the normal level. The light will continue to blink
twice every 45 seconds until the battery is fully discharged at
which time the light will turn off. Indication time will vary based
on battery pack capacity and the light setting.
Pivoting Head (Fig. A)
The pivoting head rotates in six positions ranging from 0 °–90 °.
Carrying and Suspending the Light (Fig. A)
CAUTION: When the spotlight hangs by the belt hook or
loop hook, do not shake the light or the object from which
it hangs. Do not hang the spotlight from any electrical
wires or anything that is not secure. Personal injury or
property damage may occur.
CAUTION: Only use the belt hook or the loop hook for
hanging the LED spotlight. The belt hook and loop hook
are not intended to support additional weight. Do not
attach or hang anything additional to the light or risk of
breakage may occur.
CAUTION: Do not use the belt hook or loop hook to reach
with or to support your weight in any situation.
Loop Hook (Fig. A)
The light may be carried or hung by the loop hook
in use, the loop may be folded down.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
C
Lubrication
Your power tool requires no additional lubrication.
D
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
w
can be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails
to produce sufficient power on jobs which were easily done
before. At the end of its technical life, discard it with due care for
2
. When not
our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li‑Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
WALT, have not been tested with this product, use
e
Separate collection. Products and batteries marked
with this symbol must not be disposed of with
normal household waste.
Products and batteries contain materials that
EngLIsh
WALT recommended
e
23
Advertenties
Inhoudsopgave
