ii. Securing your Child in the Child Restraint
1. While pressing the harness adjustment button, pull the shoulder harnesses
completely of the child restraint.
2. Press the red button to disengage the buckle.
3. Place the child in the child restraint and engage the buckle.
4. Pull down the adjustment webbing and adjust it to the proper length so
that your child is snugly secured.
!
After the child is seated, recheck whether the shoulder harnesses are at
proper height.
!
Make sure that the shoulder harnesses fit snugly against the shoulders of
the child (no belt slack).
Booster Mode
( for Child 15–36kg / approx. 3–12 years old)
see images
-
18
23
i. Installation
!
Just use the vehicle seat belt when installing the child restraint in the
booster mode, do no longer the internal harness system. Please store the
shoulder straps, buckle and buckle tongues in respective storage
compartments as shown in
.
20
!
Please adjust the shoulder harnesses to proper length before store the
shoulder straps and buckle in their storage compartments.
!
Please adjust the child restraint to proper angle. Angle indication: With top
triangle and red triangle aligned.
!
When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not keep the safety
belts from being properly positioned.
1. Press the red button to disengage the buckle.
2. Remove the crotch strap.
19
3. Detach the snaps and the hook and loop fasteners.
16
14
15
16
17
18
-1 &
-2
20
20
4. Lift the upper flap upward and pull the lower flap forward, and then store
the shoulder straps in their storage compartments.
5. Pull the buckle to the back of the seat pad, and then store the buckle and
buckle tongues in respective storage compartments.
6. Do reattach the snaps and the hook and loop fasteners to recover the seat
pad. The recovered seat pad is shown as
ii. Securing your Child in the Child Restraint
1. Let the child sit in the child restraint, check whether the shoulder belt
guides are at proper height.
2. Position shoulder belt through shoulder belt guide, pass waist belt through
seat slots. Fasten buckle and pull the vehicle belt to tighten.
!
Shoulder belt must pass through shoulder belt guide as shown in
!
Waist belt must pass through seat slots.
!
The child restraint can not be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the child restraint securely.
!
Never use a vehicle waist-only belt to secure your child.
!
Do not use shoulder belt loose or positioned under arm.
!
Do not use shoulder belt behind child's back.
!
Do not allow child to slide down in the child restraint in case of
strangulation.
Detach Soft Goods
see images
24
1. Remove the crotch strap.
2. Press the red button to disengage the buckle.
3. Detach the snaps on the seat pad, pull the buckle to the back of seat pad,
and then remove the seat pad.
24
!
Please do not remove any connector which fixed to the plastic when
removing soft goods.
!
To re-attach the soft goods please repeat the above steps in the reverse
order.
-3
20
&
-4
-5
20
20
21
22
-1.
23
17