Inhoudsopgave
Advertenties
9. Adjust the overhang
• Move the cartridge to adjust the overhang in
such a way the stylus tip is at 52.8mm from
the headshell mounting end.
52.8mm
• The cartridge should be parallel on the
headshell when viewed from the top.
• The cartridge should also not tilt when viewed
from the side.
• After the adjustments are complete, tighten
the screws securely.
• Attach the headshell to the tonearm.
10. Adjust the tonearm height
Note:
• The cartridge installed is a Nagaoka MP-110
with 18.5mm height.
18.5mm
• The supported cartridge height ranges from
16.5 to 22.5mm.
© sonoro audio GmbH 2021
• First, place a record on the turntable.
• Place the stylus tip on a record and check that
the tonearm is parallel to the record.
• Insert the 2mm hex wrench (not included) into
the height adjustment screw hole and turn it
counterclockwise to unlock the tonearm base.
High adjustment
Screw hole
Tonearm base
• If the height of the pickup to be replaced is
between 16.5 and 18mm, please remove the
rubber washer first before adjusting the tone
arm height.
Rubber washer
• Hold the tonearm base, and adjust the height
to make the tonearm level.
• Turn the hex wrench clockwise to lock the
tonearm base.
• Adjust the tonearm balance and tracking
force.
GB
Pedestal
43
Advertenties
Hoofdstukken
Inhoudsopgave
