Download Inhoudsopgave Inhoud
Deel
Print deze pagina
  1. Handleidingen
  2. Merken
  3. Chauvet Professional Handleidingen
  4. Verlichtingsapparatuur
  5. WELL PANEL
  6. Beknopte handleiding

Battery Charge Notes - Chauvet Professional WELL PANEL Beknopte Handleiding

Verberg thumbnails
Inhoudsopgave

Advertenties

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
Power Linking
It is possible to link up to 9 WELL Panel products at 120 VAC, 17 products at 208 VAC, or 18 products at 230 VAC. Never
exceed this number. Power-linking cords can be purchased separately.
AC Plug
Connection
AC Live
AC Neutral
AC Ground
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.

Battery Charge Notes

This product is equipped with a built-in rechargeable lithium ion battery.
•
Avoid depleting the battery below 10%.
•
For best results, charge the battery in a temperature between 32 ºF (0 ºC), and 95 ºF (35 ºC).
•
When charging the battery, keep the product at least 1 m from any open flame or hot plate.
•
If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. Allow a depleted battery to charge for a few minutes before turning on the device.
•
While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
•
Always charge the battery with the product in an upright position.
•
Do not charge the battery for more than 24 hours.
•
This product must be charged under supervision only. NEVER leave it unattended or unmonitored while charging.
Storage Notes
•
Store charged product(s) in a dry environment, away from direct sunlight.
•
Charge or discharge the battery to approximately 50% of capacity before storage.
•
Lithium-Ion batteries continue to slowly discharge (self-discharge) when not in use or while in storage. Routinely
check the battery's charge status.
•
Store the battery at temperatures between 41 °F and 68 °F (5 °C and 20 °C).
•
Always store the product in an upright position (≤ 10° tilt)
Battery Run Time
DMX Linking
The WELL Panel will work with a DMX controller using a 5-pin DMX data connection or a wireless DMX connection. A
DMX Primer is available from www.chauvetprofessional.com.
DMX Connection
The WELL Panel uses a wireless or 5-pin DMX data connection for its DMX personalities: 4Ch, 8Ch, 12Ch, 13Ch, and
21Ch. See the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The WELL Panel uses the DMX data connection for its Master/Slave mode. See the User Manual for information about
connect and configure the product for master/slave operation.
WELL Panel QRG Rev. 7
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Battery Run Time
3, 5, 8, or 12 hours
Wire (Europe)
Brown
Blue
Green/Yellow
.
Recharge Time
4 hours
EN
Screw Color
Yellow/Brass
Silver
Green
2

Advertenties

Inhoudsopgave
loading

Gerelateerde Handleidingen voor Chauvet Professional WELL PANEL

Gerelateerde Producten voor Chauvet Professional WELL PANEL

Inhoudsopgave