Inhoudsopgave
Advertenties
Bag for shredded material full
R ed LED on membrane key-
board lights.
Paper shredder stops automati-
cally.
Notice
Empty the cut material container,
immediately because if it is too full, malfunc-
tions can occur in the cutting system.
Note
Reversing the cutting device
("Reverse" button) is also possible even
when the shredded material container is full.
• Insert new bag.
For all other malfunctions, before calling
customer service please check
– if the motor was overloaded
Let the shredder cool down for approx.
15 – 20 mins. before using it again.
– if the light barrier is soiled with paper
dust.
Clean the light barrier in the paper feed
using a dry brush or cloth.
16
8 Cleaning and maintenance
Switch off the shredder and pull out the
mains plug. When cleaning only use a soft
cloth and a mild soap-water solution. How-
ever, no water must enter the equipment.
• Spray special cutting block oil
through paper feed opening
across the whole width of the cut-
ting system blades.
• Run cutting system forwards and
backwards several times without
feeding paper.
Paper dust and particles are
shaken off.
Classic 411.2
english
english
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
container:
06/2014
Advertenties
Inhoudsopgave
