Inhoudsopgave
Advertenties
Fig. 10
F
Setting deactivation time
1
Set the desired mode: cooling, drying or fan.
2
Switch the remote control on with the on/off button.
3
Press the Timer button. The arrow below the T-off and the letter H will start to
flash.
4
Use the - and + button to set the required deactivation time.
5
Whilst the arrow below T-off and the letter H are flashing, point the remote con-
trol at the display on the air conditioner and then press the timer button again.
There will be an audible signal and the Timer LED on the air conditioner will light
up.
6
To switch off the timer function, press the on/off button with the remote
control pointed at the air conditioner. The Timer LED will go out. The timer
function is now deactivated.
Replacing batteries
Remove the battery cover by sliding it in the direction of the arrow, see fig. 10.
Insert the new batteries making sure to orient the + and - poles properly and replace
the cover.
Use 2 LR03 AAA 1.5 Volt batteries. Do not use rechargeable batteries or a different type
of batteries.
AIR FILTER
The air conditioner has two screen filters to purify the air being circulated. Clean these
filters after every two weeks of use. First remove the filter at the rear of the air condi-
tioner, after which the filter in the side of the unit can be removed (see fig. 11).
Clean the filters with a soft brush. If there is stubborn dirt, the filter can be rinsed with
lukewarm water at a maximum temperature of 40 ºC. Allow the filters to dry before
replacing them in the air conditioner.
Fig. 11
4
87
Advertenties
Inhoudsopgave
