Inhoudsopgave
Advertenties
7
Troubleshooting
y The here described tasks for troubleshooting can be done mostly by the
operator.
y Some tasks only may be done by especially trained personal or by an
authorised service centre. These tasks are marked with (S).
Malfunction
Top blade does not
move
Clipper cuts badly or
not at all
Motor is not running
Motor does not work
Motor runs very slowly Clipper blades were not
Running time of a fully
charged battery is too
short and / or blades
are getting hot
The control light of
the charging station in
not on
When battery is un-
loaded the light does
not change from green
to red
Translation of the original instructions / Small animal clipper
Cause
Clipperhead is not well
engaged
Turning lever is defective
Clipper blade is blunt
Clipper blades have not
been correctly ground
Clipper blades are not oiled Oil clipper blades every 15 minutes
The animal's hair is wet
Hairs jammed between top
and bottom blades
Clipperhead has too little
clipping pressure
Battery is dead
Contacts dirty
Faulty battery
Smell of burning from
the motor housing. Motor
burned out.
Faulty motor and / or elec-
tronics
Clipperhead blocked
oiled sufficiently
Clipper blades were not
oiled sufficiently
Dead, not fully charged or
defective battery has been
used
Charging station is not con-
nected to the power supply
Charging station is faulty
Contacts of battery and/or
charging station are dirty
Faulty battery
Contacts of the charging
station are deformed
Rectification
Engage the clipperhead correctly
when the motor is running
Replace turning lever (S)
Have top and bottom blades resharp-
enend by service centre (S)
Only clip dry hair
Take off clipperhead, push the top
blade half away from the clip-
perhead, take away hairs between
top and bottom blade.
Have clipperhead inspected (S)
Charge battery
Switch clipper off and clean the
contacts
Replace battery
Have motor and / or electronics
replaced (S)
Have motor and / or electronics
replaced (S)
Clean and oil clipperhead
Oil clipper blades
Oil clipper blades
Only use intact and completely
charged original battery
Connect the charging station to the
power supply
Have charging station inspected (S)
Clean contacts
Replace battery
Have the charging station repaired
(S)
17
Advertenties
Hoofdstukken
Inhoudsopgave
