Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FJ40
GB
WARNINGS -
SAFE USAGE INSTRUCTIONS
1. Study, understand and follow all instructions before
operating this jack.
2. Do not exceed rated capacity.
3. Use only on hard level surface.
4. It is recommended to brake and chock the vehicle.
5. Do not move or transport the vehicle while on the
jack.
6. Lifting device only. Immediately after lifting, support
the vehicle with support stands. Always use support
stands in pairs.
7. Lift only on areas of the vehicle as specified by the
vehicle manufacturer, and only centrally on the lifting
saddle. Be sure setup is stable and that the load
cannot drop, slide or tip.
8. No person shall remain in, on, or get bodily under a
load that is being jacked or is supported only by a
jack.
9. Only original accessories and spare parts shall be
used.
10. No alterations shall be made to this jack.
11. Failure to follow these warnings may result in
personal injury and/or property damage.
Assembly
Seize cylinder with both hands (OBS: Mind the fingers!).
Place piston rod in hole and tighten the wing screw
(11). Place pumping handle in tipping gear and screw
locking screw completely into slot in handle. Lubricate
all moving parts.
Use
Lifting: Activate lever tube up and down using full
strokes. For a high lift, lift load to maximum with the low
saddle, support it safely, then lift by the saddle on top of
cylinder.
Lowering: Pull lever tube up, then slowly turn
clockwise.
Transport
When transporting jack, step on the nut (13) and pull
back the handle to lock it. The jack can now be driven
on the two big wheels.
Maintenance
Maintenance and repair must always be carried out by
qualified personnel.
Daily: Inspect jack for damages.
Monthly: Lubricate all mechanical parts with a few
drops of oil, and grease the end of the pump piston.
Oil refill: Correct oil level is up to lower edge of filling
hole (21) with the jack fully down and vertical cylinder.
Too much oil causes poor pumping.
Quantity of oil:
Any good hydraulic oil of viscosity ISO VG 15 can be
used.
NEVER USE BRAKE FLUID!
Safety Inspection
According to national legislation – minimum once a year
though – the jack must be inspected by a professional:
damages, wear and tear, adjustment of the safety valve,
hydraulic unit for leakages. Furthermore that all safety
labels are legible.
Trouble shooting
1. The jack does not lift to maximum height: check oil
level.
2. Poor pump function (half strokes): vacuum in the
reservoir. Loosen filling plug (21) and drain any
excess oil.
3. Problems with the release system: Readjust the play
between handle in neutral and release bracket (27)
to be 2 – 4 mm by loosening or tightening the two
nuts (11) (Please observe: the release shaft (31)
shall not rotate).
4. Air in the hydraulic system: Bleed the system. Pump
to half stroke; turn jack upside down resting on the
cylinder and then release.
5. The load is dropping: leaking pump valves or worn
seals.
Spare parts
Maintenance and repair must always be carried out by
qualified personnel. Replace worn or broken parts with
genuine jack manufacturer supplied parts only. All major
parts may not be provided after discontinuation of a
model.
Destruction
Oil must be drained off and legally disposed of.
(Translation of original text)
0,5 l.
3
Advertenties
Inhoudsopgave
