Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Step 2 Connecting devices and this unit
Names of Parts
For details, see the Operating Instructions of this unit.
TEMPO slider
FX LEVEL control
FX BEAT setup buttons
FX ON/OFF button
Jog dial
Pad mode
select button
Performance pad
SHIFT button
SYNC button
CUE button
PLAY/PAUSE f button
LOOP IN/OUT button
Connecting speakers with a built-in
amplifier to the unit with an audio
cable (RCA)
Connect speakers with a built-in amplifier, powered
speakers, etc. to the [MASTER] output terminals of this
unit.
Speakers with a built-in amplifier,
powered speakers, etc.
• For details on connecting the input/output terminals, see the
Operating Instructions of this unit.
• Turn the volume of the device(s) (speakers with a built-in amplifier,
powered speakers, etc.) connected to the [MASTER] output terminals
to an appropriate level. Note that the output sound may be loud if the
volume is set too high.
USB terminal
MASTER output terminals
MIC input terminal (1/4" TS jack) *Supported unbalanced input only
MIC LEVEL control *When not using a microphone, turn the volume to the minimum level.
Connecting your computer to the
unit
1 Connect your computer to the unit via a USB cable.
Make a direct connection with the supplied USB cable. A USB hub
cannot be used.
2 Turn on your computer.
3 Turn on the device(s) (speakers with a built-in
amplifier, powered speakers, etc.) connected to the
output terminal.
LOAD button
TRIM control
Rotary selector
EQ (HI/MID/LOW) controls
MASTER LEVEL control
CHANNEL LEVEL indicator
Crossfader
Deck 2
(right)
Deck 1
(left)
USB cable (supplied)
HEADPHONE LEVEL control
FILTER control
HEADPHONES
CUE MASTER/1/2
select button
Channel fader
PHONES output terminal
(3.5 mm stereo mini jack)
Computer
En
7
Advertenties
Inhoudsopgave
