Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Weekly: Headgear, frame and elbow
1. Soak the components in warm water with a mild liquid detergent.
2. Hand wash the components with a soft bristle brush. Pay particular
attention to the vent holes in both cushion and elbow.
3. Thoroughly rinse the components under running water.
4. Leave the components to air dry out of direct sunlight.
If the mask components are not visibly clean, repeat the cleaning steps.
Make sure that the vent holes and anti-asphyxia valves are clean and
clear.
Reassembling your mask
1. Align and insert the frame connector tab (a) into the cushion slot (b)
and press down until it clicks. Repeat on the other side.
2. Attach the elbow to the top of the frame until it clicks.
3. With the ResMed logo facing outwards and up, insert the upper
headgear straps into the frame from the inside and fold the fastening
tabs over to secure.
Note: If the elbow ring detaches, re-insert into the top of the frame.
WARNING
• Magnets are used in the lower headgear straps and the frame of the mask. Ensure the
headgear and frame is kept at least 50 mm away from any medical implant (eg,
pacemaker, defibrillator, magnetic cerebrospinal fluid (CSF) shunt valve, cochlear
implants etc) to avoid possible effects from localized magnetic fields. The magnetic
field strength is less than 400 mT.
• The mask contains safety features, the exhaust vent holes and anti-asphyxia valves, to
enable normal breathing and exhaust exhaled breath. Occlusion of the exhaust vent
holes or anti-asphyxia valves needs to be prevented to avoid having an adverse effect
English
5
Advertenties
Inhoudsopgave
