Inhoudsopgave
Advertenties
Setup and usage
You don't have to remove any components before use.
•
•
Before the use of any Tableheaters model, check whether the electrical installation to power the
heater is capable of withstanding the power of this product, whether the grounding structure is
present or sufficient, and whether there is leakage protection. Our company is not responsible
for adverse situations that may arise from ungrounded or insufficient electrical installations.
•
All Tableheaters products are covered with a cage to avoid touching the carbon heater inside the
product. Do not remove this cage. Never touch the carbon heater inside the product or insert
anything into it. Since the cage outside the product is placed to prevent direct access to the
heating elements, it should remain attached while working the heater. This protection cage may
not provide full protection for children, the elderly and disabled people.
•
The parts required for assembly of the product are available in the box of product. (8 wood
screws)
MODEL GOLD
•
Screw the 4 supplied adjustable feet into the foot of the tableheater. (Pic1. Nr 6)
•
Mount the heater on your table by screwing it through the 8 holes in the table connection piece.
The heater is not suitable for use without being mounted on the table.
Turning the thermostat button turns the device "on" or "off". (Pic1. Nr 2) The numbers on the
•
button determine the working frequency of the thermostat. In the "0" position, the device is turned
off. In "120" position, the thermostat is deactivated and works without restrictions.
•
Only mount a tabletop of max 100x100 cm on this model.
MODEL GOLD S
•
Screw the 4 supplied adjustable feet into the foot of the tableheater. (Pic2. Nr 6)
•
Mount the heater on your table by screwing it through the 8 holes in the table connection piece.
The heater is not suitable for use without being mounted on the table.
Turning the thermostat button turns the device "on" or "off". (Pic2. Nr 2) The numbers on the
•
button determine the working frequency of the thermostat. In the "0" position, the device is turned
off. In "120" position, the thermostat is deactivated and works without restrictions.
•
Only mount a tabletop of max 100x100 cm on this model.
MODEL GOLD LIGHT
•
Before mounting the product on tables made of a non-wood material, it is recommended to paste
a 30cm x 30cm x 2cm wooden piece to the table and screw the product to this piece. Products
directly adhered to the table may damage the table when trying to detach from the table again.
•
OPTION 1 : Mount the heater on your table by screwing it through the 8 holes in the table
connection piece. The heater is not suitable for use without being mounted on the table.
1). If you mount the heater to the table you must unscrew the foot. (Pic4. Nr 5). At the bottom
of this foot you need to loosen 4 screws and remove the foot. Then you can reattach the 4 screws
and close the bottom with the intermediate plate.
•
OPTION 2 :If you want to place the tableheater under the table, you do not have to remove the
foot. You then only have to adjust the foot screws which ensure a stable surface.
(Pic1. Nr 1).
(Pic2. Nr 1)
(Pic3. Nr
(Pic 4. Nr 6)
EN
Advertenties
Inhoudsopgave
