Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Lawn trimming
Move the trimmer left and right, keeping it well away from
the body. Cut higher grass in steps.
Edge cutting
Guide the trimmer along the edge of the lawn. Avoid contact
with solid surfaces or walls to prevent rapid wear of the cut-
ting line.
Cutting around trees, plants and bushes
To prevent damage, carefully cut around trees, plants and
bushes so that they do not come into contact with the cut-
ting line.
Dismounting the spool, winding up the cutting
line and mounting the spool (see figures to L)
Remove the battery before replacing the spool.
u
Press both latches of the spool cover together and remove
the spool cover (11). Afterwards, remove the empty spool
(12).
Troubleshooting
Lawn Trimmer/Lawn Edge Trimmer
Problem
Possible Cause
Motor refuses to start
Battery discharged
Battery too hot/cold
Garden tool functions
On/Off switch defective
intermittently
Internal wiring of garden tool defective
Garden product la-
Grass too high
bours
Garden tool does not
Cutting line too short/broken off
cut
Spool empty
Cutting line can no
Line inside the spool entangled
longer be fed
Spool empty
Cutting line retracts
Cutting line too short/broken off
into spool
Cutting line breaks fre-
Line inside the spool entangled
quently
Trimmer used incorrectly
Heavy vibrations
Cutting line broken
Cutting system damaged
Grass between spool housing and line-feed but-
ton
Grass in hole for line feed
Battery and charger
Bosch Power Tools
Cut off approx. 4.0 m line from the refill roll. Slide one end of
the cutting line into the hole for line wind-up (13) in the
spool and wind up the cutting line uniformly and tightly.
Slide the other end of the cutting line through the hole for
line guiding (14) in the trimmer head and mount the spool
back into the trimmer head. Affix the spool by mounting the
spool cover (11).
Line Feeding (see figure M)
Semi-automatic Line Feeding
The trimmer is equipped with a semi-automatic feeding sys-
tem. The system feeds the line with every press of the on/off
switch (4).
Manual Line Feeding
Press the line-feed button (15), and pull the cutting line out
to the desired length.
Corrective Action
Recharge battery
Allow to cool/warm
Contact Bosch customer service agent
Contact Bosch customer service agent
Cut in stages
Manually feed cutting line
Replace line spool
Inspect the spool, rewind if necessary
Refill line spool
Remove spool – rethread line (see figures J − L)
Remove spool – rewind line (see figures J − L)
Only trim with the tip of the line, avoid stones,
walls and other hard objects. Feed the line regu-
larly to maintain full cutting diameter.
Pull out cutting line with manual feed (see figure
M)
Contact Bosch customer service agent
Disassemble spool cover and remove grass
Remove grass from hole for line feed
English | 19
F 016 L94 677 | (29.06.2023)
Advertenties
Inhoudsopgave
