Inhoudsopgave
Advertenties
3. Remove the hedge trimmer from the vise and adjust
the unsharpened blade on the other side exposed.
Repeat the above procedures until all the blade teeth
sharpened.
NOTICE:
Do not operate your hedge trimmer with dull or
damaged cutting blades. This may cause overload and
will give unsatisfactory cutting results.
NOTICE:
A normal metal file is not applicable to sharpen
AHB6500/AHB7500 special blade.
NOTICE:
When use a low-speed grinder (Rotate
speed<2500 min
-1
) to sharpen cutting blade, keep
watering the blade teeth continuously during grinding.
LUBRICATING THE HEDGE TRIMMER
WARNING:
Do not lubricate while the hedge trimmer
is still connected with battery or running.
Lubricating the blade
For best operation and longer blade life, lubricate the
hedge trimmer blade with light weight machine oil before
and after each use.
Remove the battery pack and lay the trimmer onto a flat
surface. Apply the oil along the edge of the top blade
(Fig. N).
Lubricating the gear case
For best operation and longer lifetime, lubricate the hedge
trimmer gear case with a special grease (5-6g in #1 and
10-12g in #2 each time) after every 50 hours operation.
The special grease should meet the following
requirements.
1. Belong to DIN51818: NLGI-2 cone penetration degree.
2. Composed of polyurea thickeners + synthetic
lubricating oil
3. Excellent low-temperature startup, EP, mechanical
shearing, abrasion resistance and oxidative stability
properties.
4. Operation temperature must contain -40~180°C.
Remove the battery plug and the two sealing screws (Fig. O).
Lubricating the gear case through the oil-hole.
NOTICE:
Don't fully fill the gear case with grease.
56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER — HTX6500/HTX7500
TRANSPORTING AND STORING
◾
Always place the shield on the blade before storing or
transporting the hedge trimmer. Use caution to avoid
the sharp teeth of the blade.
◾
Clean the hedge trimmer thoroughly before storing.
◾
Store the hedge trimmer indoors, in a dry place that is
inaccessible to children.
◾
Keep away from corrosive agents such as garden
chemicals and deicing salts.
WARNING:
Blades are sharp. When handling the
blade assembly, wear non-slip, heavy-duty protective
gloves. Do not place your hand or fingers between blades
or in any position where they could get pinched or cut.
NEVER touch blades or service the unit with battery pack
installed.
Protecting the environment
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric tools must be returned
to an environmentally compatible
recycling facility.
EN
11
Advertenties
Inhoudsopgave
