Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Technical Data
Cross-line Laser
Article number
Working range to approx.
Levelling accuracy
– Laser line
– Plumb beam (upward)
– Plumb beam (downward)
Self-levelling range, typically
Levelling duration, typically
Operating temperature
Storage temperature
Relative air humidity, max.
Laser class
Laser type
– Laser line
– Plumb beam
C
(laser line)
6
Tripod mount
Batteries
Rechargeable batteries
Operating life time, approx.
Weight according to
EPTA-Procedure 01/2003
Dimensions
Please observe the article number on the type plate of
your measuring tool. The trade names of the individual
measuring tools may vary.
Assembly
Inserting/Replacing the Battery
Use only alkali-manganese or rechargeable
batteries.
To open the battery lid 10, press on the latch 9
and fold the battery lid up. Insert the batteries.
When inserting, pay attention to the correct po-
larity according to the representation on the in-
side of the battery lid.
Bosch Power Tools
PCL 20
3 603 K08 2..
10 m
± 0.5 mm/m
± 0.5 mm/m
± 1 mm/m
± 4°
4 s
+5 °C ... +40 °C
– 20 °C ... +70 °C
90 %
2
635 nm, <2 mW
650 nm, <2 mW
10
1/4"
4 x 1.5 V LR6 (AA)
4 x 1.2 V KR6 (AA)
40 h
0.5 kg
123 x 67 x 110 mm
Always replace all batteries at the same time.
Only use batteries from one brand and with the
identical capacity.
Remove the batteries from the measuring
tool when not using it for extended periods.
When storing for extended periods, the bat-
teries can corrode and discharge themselves.
Operation
Initial Operation
Protect the measuring tool against moisture
and direct sun irradiation.
Do not subject the measuring tool to ex-
treme temperatures or variations in tem-
perature. As an example, do not leave it in
vehicles for longer periods. In case of large
variations in temperature, allow the measur-
ing tool to adjust to the ambient temperature
before putting it into operation.
Avoid heavy impact to or falling down of the
measuring tool. Damage to the measuring tool
can impair its accuracy. After heavy impact or
shock, compare the laser lines or plumb beams
with a known horizontal or vertical reference
line or with already checked plumb points.
Switch the measuring tool off during trans-
port. When switching off, the levelling unit,
which can be damaged in case of intense
movement, is locked.
Switching On and Off
To switch on the measuring tool, push the
On/Off switch 7 to the "On" position. Imme-
diately after switching on, the measuring tool
sends out the two laser lines 1.
Do not point the laser beam at persons or
animals and do not look into the laser beam
yourself, not even from a large distance.
To switch off the measuring tool, push the
On/Off switch 7 to the "Off" position. When
switching off, the levelling unit is locked.
Do not leave the switched on measuring tool
unattended and switch the measuring tool
off after use. Other persons could be blinded
by the laser beam.
English | 13
1 609 929 R07 | (9.10.08)
Advertenties
Inhoudsopgave
