Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6 Cleaning and maintenance
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Check that the container contact is working
properly
Warning!
If the following procedure cannot be
performed, switch off the document
shredder, disconnect the mains plug
and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and tilt out the con-
tainer while the paper is being drawn in.
The cutting unit must switch off immediately
and the "container open" indicator must light
up.
• Insert the shredded material container again
fully.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening. The
light barrier must be clear.
• Switch off the machine and then switch back
on.
The cutting unit starts when paper is fed in.
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer (Cross cut only):
• Spray special cutting block oil through paper
feed opening across the whole width of the
cutting system blades.
• Let the cutting unit run without paper in brief
mode.
Paper dust and particles are shaken off.
Note:
Oiling the cutting unit also improves the cutting
performance of devices with strip cut.
12
7 Scope of delivery
• Document shredder, ready for connection,
packed in a carton
• 5 waste bags
• 1 bottle of special cutting apparatus oil
(50 ml) for devices with particle cut
• Operating instructions
Accessories:
• Waste bag, order no. 1.661.995.050
• Special cutting apparatus oil (250 ml)
order no. 1.235.997.403
0902
Advertenties
Inhoudsopgave
