Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2.1 Prior to taking the machine into service
i
Before connecting the tool to a power source, be sure the voltage supplied is the same as specified on the name plate
of the tool. The power supply should not vary more than 10% above or below the voltage indicated on the name plate.
Working with worn or damaged bevel heads will cause the machine to fail.
• Check bevel head prior to use.
• A sharp bevel head will increase cutting speed and machine life.
• The bevel head must be changed regularly.
• The bevel head must be mounted centrally and positioned against the limit stop.
• The maximum allowable speed of the tool and of the chuck may not be exceeded under any circumstances.
• Observe national regulations.
2.2 Taking the machine into service
Preselect speed with adjusting wheel according to speed table.
Adjusting wheel increment
1
2
3
4
5
6
During operation, never increase the speed of the machine to
above that of the maximum admissible speed of the grinding tool!
2.2.1 Turn on
!
• Always wear protective clothing, safety shoes, safety glasses and ear protection.
• Make sure you always have a firm footing when working with the machine.
• Whatever the position of the machine, always use two hands to control the machine.
• Never touch the bevel head when the machine is running.
• Never use the machine above head height.
• The machine should only be used for conventional up-cut milling.
• To turn the machine on, push the ON/OFF switch toward the front.
• Bring the machine slowly into contact with the work piece only after the selected tool speed has been reached.
• When cutting a bevel, always move the machine from left to right against the rotation direction of the bevel head.
• When machining bore holes, always work in a clockwise direction.
2.2.2 Turn off
• Take beveling machine from work piece and turn off.
• Motor stops.
2.3 Rating data
Power voltage (cf. replacement parts list)
Power Input
No-load speed
Max. wheel diameter
Grinding spindle thread
Weight
Sound pressure level according to EN 60745
Noise emission level
Vibration according to EN 60745
Protection class
EN
Min
/ rpm
-1
2.700
3.300
4.000
4.700
5.300
6.000
3
120/230V; 50/60 Hz
600W
max 5500 min-1/rpm
24 mm
M6
2,46Kg
81 dB (A) K = 3 dB
92 dB (A) K = 3 dB
3.0m/s2, K=1.5m/s2
/ II
Advertenties
Hoofdstukken
Inhoudsopgave
