Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installing the cable
1
2
3
Removing
waistband
Installing
waistband
Hold the cable near the machine inlet and form a straight loop;
approximately 15cm, as shown in the illustration.
Feed the cable through the slot until it passes the hook. Secure onto the
hook. Always ensure that this step is completed.
You may have to push the waistband buckle aside to allow the cable to pass
through.
Once the cable is secured onto the hook, pull the cable away from the
machine to ensure a tight fit, as shown in the illustration.
OPTIONAL HARNESS WAISTBAND
Your machine comes fitted with the optional harness waistband. To remove
it if you prefer to not use it, hold the metal clip located at the end of the
waistband and pass through the slit at the back of the harness, then through
the elasticated slot on the side of the harness.
To install the optional harness waistband, take one piece and pass through the
elasticated slot on the side of the harness and feed the metal clip through the
slit at the back of the harness, securing into place.
Velo
ENGLISH
15
Advertenties
Inhoudsopgave
Probleemoplossen
