Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5
5
GENERAL RECOMANDATION
Before you begin cleaning you must ensure that the hob
is switched off.
It is advisable to clean when the appliance is cold and
especially when cleaning the enamelled parts.
All enamelled surfaces have to be washed with soapy water
or some other non-abrasive product with a sponge and are
to be dried preferably with a soft cloth.
Avoid leaving alkaline or acid substances (lemon juice,
vinegar etc.) on the surfaces.
ENAMELLED PARTS
All the enamelled parts must be cleaned with a sponge and
soapy water only or other non-abrasive products.
Dry preferably with a chamois leather.
If acid substances such as lemon juice, tomato conserve,
vinegar etc. are left on the enamel for a long time they will
etch it, making it opaque.
STAINLESS STEEL ELEMENTS
Stainless steel parts must be rinsed with water and dried
with a soft and clean cloth or with a chamois leather.
For difficult dirt, usea specific non-abrasive product
available commercially or a little hot vinegar.
Note: regular use could cause discolouring around the
burners, because of the high flame temperature.
CONTROL KNOB
The control knobs may be removed for cleaning but care
should be taken not to damage the seal.
GLASS LID (optional)
Electric plates and gas models
Do not close the glass lid when the electrical plates are still
hot and when the oven, installed below the cooking hob is
on or still hot.
Do not rest hot pans or heavy objects on the cooker lid.
Remove any spillages from the surface of the lid before
opening.
GAS TAPS
In the event of operating faults in the gas taps, call the
Service Department.
CLEANING AND MAINTENANCE
VITROCERAMIC HOB
Before cleaning the top, make sure that it is
switched off.
Remove any encrustation using a special scraper which can
be bought (fig. 5.1).
Remove dust using a damp cloth.
Detergents can be used as long as they are not abrasive or
corrosive.
All residues of detergent must be eliminated with a damp cloth.
Keep all objects that could be melted by the heat away from
the top: plastic objects, aluminium foil, sugar or sugary
products.
If an object melts on the top, remove immediately (while the
top is still hot) using the special scraper to avoid permanent
damage to the pyroceram surface.
Avoid using knives and pointed objects as they could damage
the surface of the top.
Also avoid using abrasive sponges or wire wool which can
permanently scratch the pyroceram surface.
CLEANING ELECTRIC HOTPLATES
Always clean when the hotplate is tepid.
Use a soft cloth, dampened with water, and a little salt. To
finish off, use a soft cloth with a little oil.
Do not use water, to avoid the formation of rust.
Do not scratch the cooktop with cutting or sharp
objects.
Do not use the cooktop as a work surface.
Do not use steam jet cleaners because the humidity
could infiltrate into the appliance making it dangerous.
Fig. 5.1
29
Advertenties
Inhoudsopgave
