Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION (continued)
SPA CONTROL PANEL
J
Heater Duration Timer (HDT) Button: Use this button to select the desired length of time the
heating system should operate. Press this button and then press
of hours you wish the heater to operate before it automatically turns off , from 000 to 048 hours.
The icon will fl ash red for a few seconds and then stays red. The heating system will operate
for the amount of preset hours only. The timer takes priority over temperature, so the heater
will shut off when HDT time runs out regardless if the preset spa water temperature is reached
or not. During the HDT function, the information shown on the LED display alternates between
the remaining heater operating hours and the water temperature. Repeat previous steps to
reprogram this function. To deactivate the function at any time, simply set the HDT time back
to 000. To readjust the preset hours, press the HDT button twice and adjust the hours with
and
buttons.
Example 2: Using the same scenario as example 1 above but rather than manually turning the
heater off when you are fi nished, you would like the heater to turn off automatically on Saturday
evening at 9:00pm. After going through the steps in example 1, press the HDT button and then
the
or
button to select 048 hours. The heater will then run from Thursday at 9:00pm to
Saturday at 9:00pm.
NOTE: If HST and HDT timers are both set, the LED display will fi rst alternate between
remaining time before the heater start and the water temperature, until HST timer runs out and
the heater activates. Then the LED display alternates between remaining HDT time and water
temperature until the HDT timer runs out as well.
LED Display: Once plugged in the LED displays the current water temperature automatically.
If the control panel (3) is activated and away from the control base charging dock, the LED
display will go blank after 5 minutes. Press any button to resume the control panel.
Always check the control panel battery indicator. Recharge the control panel after each use.
Adjustment Buttons: Press the increase or decrease buttons to adjust the desire function
settings. Press and hold the button will rapidly increase or decrease the numbers.
Celsius/Fahrenheit Toggle Button: The temperature can be displayed in either Fahrenheit or
Celsius. The system's default is Celsius.
NOTE: The default temperature is 20°C (68°F). Temperature adjustment ranges from 10°C
(50°F) to 40°C (104°F).
WiFi Pairing Button: Touch this button for 5 seconds to begin spa WiFi pairing with your
mobile device.
S AVE THESE INSTRUCTIONS
(351IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 04/18/2022
K
J: Heater Duration Timer (HDT) Button
K: LED Display
L: Increase Button
L
M: Decrease Button
M
N: Celsius/Fahrenheit Toggle and WiFi Pairing Button
N
351
English
A
or
to set the number
Page 18
Advertenties
Inhoudsopgave
Probleemoplossen
