Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION (continued)
SPA CONTROL PANEL
G
I
Sanitizer Button: Use this button to activate and set operating hours for the sanitation
system.
Heat Button: Press this button to activate the heating system. Press
desired water temperature. The heater will continuously heat until the water temperature
reaches the set temperature and then hold at that temperature. This is achieved by the heater
restarting automatically whenever the water temperature drops 1-2°C (1.8-3.6°F) below the set
temperature. When the fl ame icon on the display is red, the heating system is activated. When
the fl ame icon turns green, the water is at the set temperature. The heating system is then at
rest, but the fi ltration system will continue circulating water nonstop, unless manually turned off .
If the heating system is reactivated, the fi lter pump will restart at the same time.
NOTE: To stop the fi ltration system while the heater is at rest mode, press the fl ame button
fi rst and then the fi lter button. Pressing the heat button only while the heater is at rest mode will
turn off the heating system only and the fi ltration system will operate for 1 more minute before
it turns off or continue with the fi lter pump preset operating hours. To turn the heater off while
heating, press the fl ame button.
IMPORTANT: The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5.4 m/s).
• The jet or bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
Heater Start Timer (HST) Button: Use this button to select a future start time for the heating
system. Press this button and then press
wish to delay the start of the heating system, from 000 to 120 hours. The icon will fl ash red for a
few seconds and then stays red. The information shown on the LED display alternates between
the remaining hours before heater start and the water temperature. Once the countdown timer
reaches 000, the heating system will start operating. To deactivate the function at any time,
simply set the HST time back to 000. To readjust the preset hours, press the HST button twice
and adjust the hours with
Example 1: It is 9:00pm Monday evening and you would like the spa to be hot on Friday
evening. Allowing for 24 hours for the spa to heat up (4 persons model about 1.5-2.5ºC (3-4.5ºF)
per hour) the heater should be set to start on Thursday evening. With the Spa turned on, fi rst
press the Heat button and set your desired temperature. Press the HST button and then
or
until 072 hours is shown. The heater will start after 72 hours has passed (Thursday at
9:00pm) and will run until the desired temperature is attained. The heater will then cycle on
and off to maintain the set temperature until turned off . To turn off the heater, press the fl ame
button.
S AVE THESE INSTRUCTIONS
(351IO) SPA (JET + BUBBLE) ENGLISH 7.5" X 10.3" PANTONE 295U 04/18/2022
H
G: Sanitizer Button
H: Heat Button
I: Heater Start Timer (HST) Button
or
to set the number of hours by which you
and
buttons.
351
English
A
or
to set the
Page 17
Advertenties
Inhoudsopgave
Probleemoplossen
