Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
www.motralec.com / service-commercial@motralec.com / 01.39.97.65.10
OBJ_BUCH-2909-001.book Page 19 Tuesday, July 19, 2016 2:15 PM
English | 19
Assembly
Battery Charging (Accessory)
Note: The battery supplied is partially charged. To ensure full capacity of the battery,
completely charge the battery in the battery charger before using your power tool for
the first time.
The lithium-ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 2, press the unlocking button 3 and pull the battery out of the
cordless worklight. Do not exert any force.
Observe the notes for disposal.
Operation
Initial Operation
Inserting the battery
Insert the charged battery 2 into the lamp head 1 until you feel it engage.
Switching On and Off
To start the cordless worklight, press the On/Off switch 9.
To switch off the cordless worklight, press the On/Off switch 9 again.
To save energy, only switch the cordless worklight on when using it.
Adjusting the Brightness
Press the On/Off switch 9 briefly to switch on the cordless worklight at maximum
brightness. To adjust the brightness in 2 stages, hold down the On/Off switch 9 until
the required brightness is obtained.
Temperature Dependent Overload Protection
When exceeding the allowable heat-sink temperature of 50 °C, the cordless worklight
switches off. Allow the cordless worklight to cool down, then switch the cordless
worklight on again.
Bosch Power Tools
1 609 92A 2MM | (19.7.16)
Advertenties
Inhoudsopgave
