Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
4. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 10-38°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
12°C/12-20°C.
TEMPERATURE SETTING
ON/OFF switch, turn on by pressing once, turn off by pressing and
A
holding 5 seconds.
B
Decrease temperature of 1 degree Celsius or Fahrenheit.
C
Raise temperature of 1 degree Celsius or Fahrenheit.
D
Display shows upper zone temperature at its setting.
E
Temperature display in Celsius.
F
Temperature display in Fahrenheit.
G
Display shows lower zone temperature at its setting.
Compartment selecting switch (lower or upper one). Once the
compartment has been selected, it will show setting temperature as
H
flash, 5 seconds later flash will stop and setting temperature will be
showing
Alarm cancel switch, press once to cancel the alarm. Press and hold 5
I
seconds to change Celsius or Fahrenheit.
J
Light ON/OFF switch, turn on and turn off the light.
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is adjustable with the
range 5-12°C, which is ideal for storing sparkling and white wines. The temperature setting of lower zone is
adjustable with the range 12-20°C, which is ideal for storing white and red wines.
NOTE: both two zones temperature could be set at 12ºC, and it is workable at the same time. But for
optimal performance, once one zone is set at 12ºC, we suggest another setting for the other zone with
3°C difference at minimum (example: 5°C upper and 8°C lower). Maximum temperature difference
between both compartments is 10°C. Always set cooler temperature in the upper compartment and
warmer temperature in the lower compartment (example: 5°C upper and 15°C lower).
• To select the temperature zone, press (H) once, upper zone will flash, (H) key pressing again to switch it to
lower zone. Setting temperature could only be set under display flash status.
• You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The degrees
indicators will appear in the display window marked
• When the unit is plugged in for the first time, the LED readouts will show the original temperature set
previously. Touch the "+" (C) and "-" (B) mark once of each compartment to set the desired temperature.
• The temperature will increase by 1°C or 1ºF if you touch the "+" (C) mark once, or the temperature will
decrease by 1°C or 1ºF if you touch the "-" (B) mark once.
for upper zone and
for lower zone.
Advertenties
Inhoudsopgave
