Inhoudsopgave
Advertenties
Before first use
1. Unpack the appliance, then check and make sure that all accessories,
including ice basket, ice scoop, etc., are present. Please contact customer
service if any accessories are missing.
2. Please make sure the ice maker is level and placed on a stable table
or platform to avoid malfunction.
3. The tilt angle of the ice maker housing should not exceed 45° during
transport or use. Do not turn the ice maker upside down. This could cause
the compressor or refrigeration system to malfunction. Please allow
compressor fluids to stabilize after moving or transporting the ice maker.
Before using the ice maker for the first time, please wait 2 hours for the
unit to be level and positioned correctly.
4. The device should be placed on a dry, horizontal surface with sufficient
ventilation, away from corrosive gases and heat sources such as ovens
and radiators. Leave approximately 6 inches (15 cm) of space on all
sides of the ice maker for proper ventilation.
5. Do not fill the water tank with hot water. This can damage the ice
maker. Better to fill the water tank with water at room temperature or
lower.
6. Do not use the device in a very cold environment (temperature lower than 5℃).
7. Clean the appliance following the operations in the "CLEANING
AND MAINTENANCE" chapter before using it.
Using your ice maker
1. Make sure the drain plug at the bottom of the water tank is tightly closed.
2. Plug the ice maker into an electrical outlet, the "
indicator will flash.
NOTE: Please be sure to let the ice maker sit for 30 minutes before plugging it
in if it has been moved.
3. Open the top cover and remove the ice cube basket.
4. Fill the water tank with potable water. NOTE: Do not fill past the MAX
water level mark.
5. Replace the ice basket and close the top lid.
6. Press the "
ON/OFF" button and the "
POWER" indicator lights
EN-12
POWER"
Advertenties
Inhoudsopgave
