Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Have defective switches replaced by an
authorized service centre.
Do not use the tool if the switch does not
turn it on and off.
21. WARNING!
The use of any accessory or attachment
other than one recommended in this in-
struction manual may present a risk of
personal injury.
22. Have your tool repaired by a
qualified person
This electric tool complies with the rele-
vant safety rules. Repairs should only
be carried out by qualified persons us-
ing original spare parts, otherwise this
may result in considerable danger to
the user.
Before use
Note: Remove all packaging material from
the product.
The operator should stand in front and
stay close to the power tool to prevent
overreach.
In case of blockage, switch off the ap-
pliance and unplug from the mains. Then
clear the jam.
Initial use
Grinding drills
Note: First rough grind severely damaged
drills with a grinding block.
Fully lower the brick. To do so, turn the
dial
all the way in the DOWN ▼
1
direction.
Insert the drill into the smallest drill guide
on the sharpener it will fit. Please
11
refer to the markings (3 to 13) for the
exact sizes (Ø) of the respective drill
guides
.
11
Set the ON / OFF switch
"I" to switch on the product.
Turn the dial
in the UP ▲ direction
1
until you hear a grinding noise.
Note: The dial
controls the position
1
of the brick inside the grinding head, thus
the grinding pressure the brick applies
to the drill. The more the dial
in the UP ▲ direction, the greater the
grinding pressure. Be sure not to raise
the brick too high. The brick may other-
wise get in contact with the housing.
Loosely and quickly rotate the drill back
and forth about 10 times between the left
and right stop, applying light pressure
(small drills about 5 times).
Slightly pull out the drill, turn 180°
around its own axis and reinsert up to
the brick.
If necessary, repeat the entire process
until both faces are sharp. Polish so the
angle ( ) between the two cutting edges
(b) is 118°. Both cutting edges (b) must
have the same angle to the drilling axle
(a) and have the same length for the
drill to run centred (see images below).
to position
4
is turned
1
GB/IE
19
Advertenties
Hoofdstukken
Inhoudsopgave
