Inhoudsopgave
Advertenties
•
The product is for decorative purposes only and not suitable as a household room illumination.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his
service agent or a similar qualified person in order to avoid a hazard.
•
The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit must be
discarded..
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily
operable.
FUSE REPLACEMENT
Locate and remove the unit's power cord. Once the cord has been removed located the fuse holder located inside the power
socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder. Remove the bad fuse and
replace with a new one.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support for further
instructions. Continuing to use the unit may cause serious damage.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid vibration
and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure and is able to
support a weight of 10 times of the unit's weight.
Never stand directly below the device when mounting, removing or servicing the fixture.
FIXTURE LINKING
You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run synchronized
shows on two or more fixtures set to a master/slave operating mode. The combined number of channels required by all fixtures
on a serial data link determines the number of fixtures that the data link can support.
Important: Fixtures on a serial/data link must be daisy chained in one single line. Maximum recommended serial data link
distance: 100 meters (1640 ft.) Maximum recommended number of fixtures on a serial data link: 16 fixtures
DATA CABLING
To link fixtures together you must use data cables. If you choose to create your own cable, please use data-grade cables that
can carry a high quality signal and are less prone to electromagnetic interference.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the
other end.
DMX connector configuration
Termination reduces signal errors. To avoid signal transmission problems and interference, it
is always advisable to connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the common can cause a ground
loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct polarity and to make sure the
pins are not grounded or shorted to the shield or each other.
POWER LINK
The unit is fitted with POWERCON IN and OUT connectors. Up to 6 units can be daisy-chained and powered via the first unit
that is connected to the mains. The maximum allowable power is 900W.
LED DISPLAY
The LED display has 4 buttons: MENU / UP / DOWN / ENTER
MANUAL - FXBAR140
SYSTEM MENU
Press any key to enter
the initial interface.
3
Advertenties
Inhoudsopgave
