Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
GETTING STARTED
Position the main unit, rain gauge, and thermo sensor
within effective range:
•
Rain gauge - 00 meters / 328 feet
•
Thermo sensor - 00 meters / 328 feet
IMPORTANT It is recommended that you follow the
sequence below when setting up the units:
. Set up the main unit.
2.
Set up the rain gauge, then press and hold SEARCH
on the main unit and wait until you receive a
signal.
3.
Set up the thermo sensor, then press and hold SEARCH
on the main unit and wait until you receive a
signal.
4.
In the event that you do not obtain a signal from a
remote unit please repeat the process above.
MAIN UNIT
.
Insert the batteries, matching the polarity (+ and -)
as shown in the battery compartment.
1
2
2.
Press RESET, or press and hold SEARCH on the
main unit to initiate operation. The reception icon
on the main unit will blink while it is searching for
the sensor or rainfall gauge.
NOTE Every time the battery in the main unit is changed,
repeat installation before use.
RAIN GAUGE
The rain gauge collects rain and takes readings of rainfall
rate and the total rainfall over a period of time. The
sensor can remotely transmit data to the base station.
The base station and rain gauge should be positioned
within an effective range: about 00 meters (328 feet)
in an open area.
The rain gauge should be mounted horizontally about
meter (3 feet) from the ground in an open area away from
trees or other obstructions to allow rain to fall naturally
for an accurate reading.
To set up the Rain Gauge:
3
5
1
2
Advertenties
Hoofdstukken
Inhoudsopgave
